Filter
Top Products
Removal and Installation
8-27
HP DesignJet CP Series Printers
Installation of the Service Station Assembly
1. Release any cable clamps that may be wrapped around the service
station to protect it while in transportation.
Note: On the service station assembly there are two locating
pins, these will help you to align the service station assembly to
the right hand side chassis.
Note: Be careful not to damage the service station flag while
performing the following procedure.
2. Install the service station assembly onto the three loosened T-20 screws
(item 4). Tighten the screws.
3. Install the T-20 screw (item 3) securing the service station.
Note: Make sure the tubes (item 8) are not bent or twisted.
4. Install the black service station interconnect cable (item 1) to the service
station interconnect PCA, this is located under the service station
assembly.
Note for HP DesignJets 3500CP/3000CP: Make sure you
reconnect the Media Button Cable (Item 10) to the Service
Station Interconnect PCA.
5. Install the following:
1. Right Hand Cover ' page 8-21.
2. Window and Top Cover ' page 8-15.
6. Install the power cable and turn the printer on in service mode.
7. Enter service test and perform D05 service station test ' page 4-16
8. Install the ink delivery system (Refer to the User Guide).
Installation of the Service Station Flag
1. Position the flag (item 7) horizontally, then push up into a retaining
clip on the service station assembly. The correct clip on the flag is
shown as (item 9).
2. Install the spring (item 6) from the service station flag to the service
station assembly.