Filter
Top Products
Removal and Installation
8-3
HP DesignJet CP Series Printers
Starguard Assembly 8Ć60. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Bail Stepper Motor 8Ć62. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Refill Interconnect PCA 8Ć64. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
XĆAxis Assembly 8Ć66. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overdrive Assembly and Drive Roller (Only 2500CP/2000CP) 8Ć69. . . . .
Overdrive Assembly and Drive Roller (Only 3500CP/3000CP) 8Ć72. . . . .
Entry Platen 8Ć78. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Roll Cover and Roll Feed Assemblies 8Ć81. . . . . . . . . . . . . . . . . . . . . . . . . .
Pincharm Assemblies, Pincharm Shaft and Pincharm Sensor 8Ć84. . . . . . .
Interconnect Cables 8Ć87. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Media Button (Only DesignJets 3500CP and 3000CP) 8Ć90. . . . . . . . . . . .
Introduction
This chapter is a step by step guide to the removal and installation of the
key components in the printer. You may find it useful to tick off the steps as
they are performed. Use the illustration at the end of each procedure to
identify the parts referred to in the text.
The procedures appear in order of removal. So the whole machine can be
stripped down by starting at the beginning of this chapter and working
through the subsequent procedures.
Before using this chapter to remove and install a new component,
always make sure that you have performed the relevant service test
from Chapter 4. If the test passes you will not need to replace the
component.