Filter
Top Products
2-18 System Error Codes
HP DesignJet CP Series Printers
System Error: 010110
Problem Description: The content of the permanent configuration area
of the EEROM is not valid when the printer is
initialized in Service Mode.
Corrective Action: Try the following:
D Test the Electronics Module ' page 4-7.
D Perform the following Calibrations:
S Carriage ' page 5-7.
S Refill ' page 5-9.
S Line Sensor ' page 5-10.
S Printhead Alignment ' page 5-13.
S Color Calib. ' page 5-16.
S Service Accuracy ' page 5-17.
D Make sure you have the latest version of the
Flash SIMM (firmware) installed.
D Replace the Electronics Module ' page 8-6.
System Error: 010111
Problem Description: The content of the User configuration area of the
EEROM is not valid when the printer is
initialized.
Corrective Action: Press ENTER and re-configure the front panel
settings. If the error code continues to appear then
replace the Electronics Module ' page 8-6.