Filter
Top Products
Service Calibrations
5-7
HP DesignJet CP Series Printers
C01. Carriage
The purpose of this calibration is to calibrate the temperature from which
the printhead has to be warmed.
THIS CALIBRATION MUST BE DONE WITH THE PRINTHEADS
INSTALLED.
Perform the Carriage calibration whenever the:
D Carriage is disassembled or replaced.
D Electronics Module is replaced.
Perform the Carriage Calibration as follows:
1 In the Calibrations submenu, scroll to “C1 Carriage” and press Enter.
Calibrations
C1 Carriage
2 The message “Remove Printheads / Press Enter” will be displayed on the
front-panel. Remove the Printheads and press Enter when you have
removed them.
3 While the Calibration is being performed, a row of “***” will be displayed
on the front-panel.
4 If the calibration is performed correctly, the “C0100 OK” message is
displayed on the front-panel.
5 Press Previous and the “Reinstall Printheads” message is displayed on
the front-panel. Reinstall the Printheads into the correct stalls in the
carriage.
6 If the calibration fails, one of the following messages will be displayed on
the front-panel:
D “C0101 Fail” - The Cyan Printhead has failed.
D “C0102 Fail” - The Magenta Printhead has failed.
D “C0103 Fail” - The Cyan and Magenta Printheads have failed.
D “C0104 Fail” - The Yellow Printhead has failed.
D “C0105 Fail” - The Cyan and Yellow Printheads have failed.
D “C0106 Fail” - The Magenta and Yellow Printheads have failed
D “C0107 Fail” - The Cyan, Magenta and Yellow Printheads have failed
D “C0108 Fail” - The Black Printhead has failed.
The calibration is continued on the next page.