Filter
Top Products
System Error Codes
2-13
HP DesignJet CP Series Printers
Primer
46 20%
Elevator
52 20%
System Error: 010037
Problem Description: ADC Test Failure in the Carriage PCA.
Corrective Action: Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8-36.
D Replace the Carriage Assembly ' page 8-42.
D Replace the Electronics Module ' page 8-6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
System Error: 010038
Problem Description: A Printhead voltage could not be set - Main PCA
Failure.
Corrective Action: Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8-36.
D Replace the Electronics Module ' page 8-6.
D Replace the Carriage Assembly ' page 8-42.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.