Filter
Top Products
System Error Codes
2-17
HP DesignJet CP Series Printers
System Error: 010100
Problem Description: Error reading the EEROM.
Corrective Action: Replace the Electronics Module ' page 8-6.
System Error: 010101
Problem Description: An action outside the EEROM limits has been
performed.
Corrective Action: Make sure you have the latest version of the Flash
SIMM (firmware) installed or upgrade the
firmware revision of the Flash SIMM ' page 1-3.
If the error code remains after installing the latest
Flash SIMM then report the error to the HP
Response Center or the nearest HP Support
Office, stating the following information:
D Model and Serial Number of the printer.
D the complete error number.
D service print (Utilities / Service Tests).
D plot file where the error has occurred.
D additional comments about the usage, the
setting, etc..
System Error: 010102
Problem Description: Physical EEROM write and/or write operations
failed. The EEROM data that is written does not
match the data that is read.
Corrective Action: Replace the Electronics Module ' page 8-6.