HP (Hewlett-Packard) 2000CP 2500CP Printer User Manual


 
User Messages
3-15
HP DesignJet CP Series Printers
Message Explanation and Action
System error
XXXXXX
An internal error has occurred and a system error number is displayed.
Press Enter; this may clear the error and allow you to continue. If you
cannot continue, turn off the printer, and then turn it on again. If you still
see the system error message then refer to Chapter 2 for more information.
System error
XXXXXX
XXXXXXXX
An internal error has occurred and a system error number is displayed.
Press Enter; this may clear the error and allow you to continue. If you
cannot continue, turn off the printer, and then turn it on again. If you still
see the system error message then refer to Chapter 2 for more information.
UV inks YES
installed ΝΟ
After you have finished installing a new ink cartridge, you are asked to confirm
that you have changed the type of ink cartridges from Imaging to UV Pigmented.
Press to confirm that you have changed the ink cartridges from Imaging to UV
Pigmented.
Press to indicate that you have not changed the ink cartridges from Imaging to
UV Pigmented. You will then be given the opportunity of replacing the incorrect
ink cartridges by the correct ones.
Verify ink system
JJ-J
At power-on, the printer has detected an error in the ink systems shown by
flashing squares.
Press to continue. You should check the ink systems immediately.
STATUS Messages
Message Explanation and Action
STATUS
Accessing head
cleaners
You have pressed the Replace Ink System key or there is an error in the head
cleaners and you have pressed or . The carriage is moving so that you can
access the printhead cleaners.
Wait until the carriage is in position.
STATUS
Accessing printheads
You have pressed the Replace Ink System key or there is an error in the
printheads and you have pressed or . The carriage is moving out so that
you can access the printheads.
Wait until the carriage is in position.
STATUS
Aligning printheads
The printer is printing a pattern to align the printheads.
Wait until the pattern has been printed.