Filter
Top Products
Removal and Installation
8-21
HP DesignJet CP Series Printers
Right Hand Cover and Right Hand Trim Assembly
Refer to figure 6 ' page 8-23
Removal
1. Remove the ink delivery system (Refer to the User Guide).
WARNING
Switch off the printer and remove the power cable.
2. Remove the left hand back cover.
3. Disconnect the front panel cable from position J1 FRONT PANEL on
the electronics module.
4. Disconnect the stand-by button cable from position J2 ON/STBY on the
electronics module.
5. Remove the following:
1. Window and Top Cover ' page 8-15.
6. Open the door on the right hand cover (item 1).
Note: Position the pinch-arm lever at half way to enable you to
perform the next step (item 2).
7. Remove the right hand trim assembly (item 3) by removing five T-15
screws (item 4) and disconnecting two cover sensors (item 5) located on
the inside.
Be careful not to drop the cover (item 7) once the securing
fasteners have been removed. Support the cover throughout the
next step.
The right hand cover and window sensors can be removed by
disconnecting them from the front panel assembly.
8. Remove the three T-15 screws (item 6) securing the right hand cover to
the right hand side chassis.
9. Remove the right hand cover (item 7), carefully passing the front panel
cable and the stand-by button cable through the hole in the right hand
side chassis.