Filter
Top Products
Removal and Installation
8-37
HP DesignJet CP Series Printers
Installation
1. Connect the trailing cable into the three connectors on the carriage PCA.
2. Install the trailing cable (item 1) onto the trailing cable carriage clamp
(item 2). Align the printed red line on the trailing cable as shown.
3. Install the trailing cable into the trailing cable holder (item 3).
4. Pull the trailing cable through a hole in the rear of the Y-axis assembly
(item 4).
5. Pull the trailing cable through a hole in the electronics support frame
(item 5).
6. Install the cable through three cable clamps, on the rear of the printer
(item 6).
7. Feed the cable through the ferrite at the rear of the printer (item 7).
8. Install the following:
1. Electronics Module ' page 8-6.
2. Right Hand Cover ' page 8-21
3. Window and Top Cover ' page 8-15
9. Connect the trailing cable to the following positions in the electronics
module:
1. J3 MISC
2. J5 DATA
3. J10 SUPPLY
10.Move the carriage to the left and right to ensure the trailing cable does
not interfere with the movement of the carriage.
11. Connect the power cord and turn the printer on in service mode.
12.Perform the D01 Electronics service test ' page 4-7.