Filter
Top Products
Checking the Forms Alignment
Do this task when you see a CHECK FORMS ALIGNMENT message or whenever you
load, splice, or adjust forms.
1. At the upper rear transfer station tractor cover plate, ensure that the forms
perforation is aligned with the correct forms length.
2. If the forms perforation is not aligned correctly, do the following:
a. Use the Forms Feed key on the Printer Control Panel to adjust the position
of the perforation.
3. If you are using the on-board stacker, ensure that the Forms Set indicator on
the Printer Control Panel is set to match the fold direction of the first fold
perforation below the perforations on the forms guide.
4. If you are doing this procedure as a step in a Printer Error or Intervention
Required procedure, continue with the steps in that procedure.
5. If you are doing this when you load, splice, or adjust forms, SELECT the
Ready pushbutton on the Display Touch Screen window for the affected printer
to continue processing.
HC6OG094
84 InfoPrint 3000 Operator’s Guide
|
|
|