Filter
Top Products
Adjusting the Preheat Temperature
The Preheat selection in Form Characteristics box of the Define Form window
allows you to increase the preheat platen temperature to enhance fusing of labels
or heavy-stock forms. You increase or decrease the temperature in increments of 5°
until optimum fusing is achieved. You should not use the lower temperature
settings to print on some synthetic forms, such as vinyl- or latex-impregnated
forms.
When you are using regular forms, the temperature should be set to the default
value. The default value is set in “Printer Configuration”.
To adjust the preheat platen temperature, do the following:
v SELECT the Configure pull-down menu on the main Display Touch Screen
window.
v SELECT the Define Form procedure.
v SELECT the Form Name for which you want to change the preheat temperature.
v SELECT the Preheat field. A keypad window appears.
v ENTER the new temperature in increments of 5° (such as 75°, 85°, 90°).
Note: To use the default temperature that is set during printer configuration,
ENTER 0 (zero), not the default temperature.
v SELECT the OK pushbutton.
v Print several hundred feet of forms at the new temperature.
v Check the fusing to see if it is acceptable. If it is not, repeat the procedure.
Operate
Configure
Analyze Options Help
Check Reset NPRO Cancel Job
Ready
Printer Status
HC6OG082
Width
OK Delete Help
8.50
Unit
in.
mm
Define Forms
Form Description
New Form...
Letter
Cancel
Length
Select a Form Name
Form Characteristics
Standard
2UpLetter
12x18
Pinless: No
Pinless mark: Preprinted form
Printable width:Normal width
Preheat: 0
12.00 Standard 8.5 x 12 in.
Search...
150 InfoPrint 3000 Operator’s Guide