Filter
Top Products
37. Remove the Toner Collector Case.
38. Vacuum any spilled toner from around and under the Toner Collector Case.
39. Use a soft cloth to clean the inside cover surfaces in the rear service area.
40. Vacuum any paper dust, chads, and other debris from the fuser oil reservoir
area.
41. Close all covers securely.
42. Use a soft cloth that is moistened with water to clean the covers and panels.
Important Note About Cleaners
Do not use commercial cleaners that might contain ammonia, solvents, or
other volatile chemicals. The vapors from these cleaners can cause
chemical reactions that result in reduced print quality.
43. Power on the printer. See “Controlling the System Power” on page 56.
44. Load forms into the printer, if necessary. See “Loading Forms (Simplex or
Dual Simplex Mode)” on page 102 or “Loading Forms (Duplex Mode)” on
page 115 for details.
This step is not required if you did not unload forms before starting this
procedure.
45. Enable the host attachments, if necessary. See “Enabling and Disabling
Attachments” on page 63 for details.
100 InfoPrint 3000 Operator’s Guide