Filter
Top Products
This chapter contains step-by-step instructions for performing most printer
operator tasks. The tasks of enabling and disabling attachments, shutting down
and restarting the system, and controlling system power are grouped together in
the front of the chapter. The remaining tasks are not presented in order of
importance or frequency of use.
Notes to the Operator:
1. In some cases, the tasks described in this chapter correspond directly to the
action messages you see on the Display Touch Screen windows.
2. The instructions in this section describe exactly how to do each step. They also
include tips to help you prevent common problems. Before you begin an
unfamiliar task, read all the information. Then carefully follow the step-by-step
instructions.
3. For information about other operator tasks, see “Chapter 8. Configuring the
System” on page 217 and “Chapter 7. Ordering and Replacing Supplies” on
page 175.
Controlling the System Power
The following figure shows a Power Control Panel.
Printer 1 in a duplex or dual simplex printing system has two sets of power
controls. One is for the Printer Utility Module (PUM) frame, which is labeled
Control Unit on the Power Control Panel. The other is for the printer that is
attached to the PUM frame.
Printer 2 in a duplex system and a simplex-only printer also has two sets of power
controls. One is for the Advanced Function Common Control Unit (AFCCU) frame,
which is labeled Control Unit on the Power Control Panel. The other is for the
printer that is attached to the AFCCU frame. Each element in the system (Printer 1
frame, Printer 2 frame, the AFCCU frame, and the PUM frame) has the following:
v A Local/Remote switch
v A Power On switch
v A Power Off if in Local switch.
These switches allow many combinations of Local/Remote power control and
power on/off control. Each Power Control Panel in the system also contains a Unit
Emergency switch.
56 InfoPrint 3000 Operator’s Guide