Filter
Top Products
Simplex and Dual Simplex Printing Applications
The configuration that is shown in “Left Angle Configuration for Dual Simplex” on
page 8 supports simplex (single-sided) printing in the Dual Simplex mode on
selected models (see Table 1 on page 2). Both printers in the configuration can run
independent simplex applications. The forms path would start at the forms input
area or preprocessing device and proceed through to either the printer output
stacker or to a postprocessing device.
When the printing system is configured as dual simplex and one of the printers is
inoperable, the remaining printer can run independently so long as power and
connection to the control unit are maintained.
Alternatively, forms can remain threaded continuously through both printers in a
duplex physical configuration, but with printing occurring in simplex mode.
Printing occurs on only one printer, while the other printer processes blank pages.
Note: Each printer can have its own set of preprocessing and postprocessing
devices.
Both printers in the configuration attach to a host system through the AFCCU. The
AFCCU controls both printers independently and is physically attached to Printer
2 in the configuration.
Chapter 1. Introduction 5