Filter
Top Products
Operator Tips on Removing Forms From The Stacker
Do not attempt to remove a full stack from the stacker.
v Limit the maximum weight of the stack by breaking the output into
small stacks (start with 150 mm (6 in.) high) by separating the forms at
convenient perforations.
v Use a ruler, knife, or letter opener to break hard-to-reach perforations
when you separate forms.
v Follow these guidelines when you lift forms out of the stacker:
a. Ensure that you can stand safely without slipping.
b. Try to keep your back straight and balance the weight of the forms
between your feet.
c. Use a slow lifting force. Never move suddenly or twist when you
attempt to lift.
d. Lift by standing or by pushing up with your leg muscles. This
action removes the strain from the muscles in your back.
7. Remove the output from the stacker.
8. On the stacker control panel, press the stacker table UP switch.
9. Close the stacker gate.
10. To continue, SELECT the Ready pushbutton on the Display Touch Screen
window.
Note on Adjusting the Height of the Output Stack
You can adjust the stacker table to limit the output stack height and weight.
Raising the stacker table lessens the height and weight of the stack, but
causes the STACKER FULL message to appear more frequently. To adjust the
stacker table height, see “Adjusting the Stacker Table Height” on page 117.
Chapter 6. Operator Responsibilities 171