Filter
Top Products
Table 16. Printer Configuration Items (continued)
Configuration Item Description Value Options
Cut Sheet Emulation Sheets are divided in half using an imaginary line that is
parallel to the tractor strips. Each resulting ″half sheet″ is
treated as if it were a whole sheet running through a
cut-sheet printer.
None implies the cut-sheet emulation is not enabled.
Normal Left-to-Right allows the print data to be placed
on the left half-sheet first and then the right half-sheet.
The left half-sheet is closest to the operator. The physical
orientation of the data is based on the lower-left corner of
the paper as viewed from the operator’s viewpoint.
Normal Right-to-Left allows the print data to be placed
on the right half-sheet first and then the left half-sheet.
The right half-sheet is furthest from the operator. The
physical orientation of the data is based on the lower-left
corner of the paper as viewed from the operator’s
viewpoint.
Inverted Left-to-Right allows the print data to be
placed on the left half-sheet first and then the right
half-sheet. The left half-sheet is furthest from the
operator. The physical orientation of the data is based on
the upper-right corner of the paper as viewed from the
operator’s viewpoint. This mode is the ″upside down″
version of the Normal Left-to-Right mode.
Inverted Right-to-Left allows the print data to be
placed on the right half-sheet first and then the left
half-sheet. The right half-sheet is closest to the operator.
The physical orientation of the data is based on the
upper-right corner of the paper as viewed from the
operator’s viewpoint. This mode is the ″upside down″
version of the Normal Right-to-Left mode.
None,
Normal Left-to-Right,
Normal Right-to-Left,
Inverted Left-to-Right,
Inverted Right-to-Left
BTS Installed This entry allows setting whether a
Burster/Trimmer/Stacker postprocessing device is
installed. It does not show whether it is being used.
YesorNo
BTS Enabled This entry allows setting whether an installed
Burster/Trimmer/Stacker postprocessing device is being
used. The host system will not send eject-to-front-facing
commands if the BTS is enabled.
YesorNo
Offsetter Installed This entry allows setting whether an Offsetter
postprocessing device is installed. It does not show
whether it is being used.
YesorNo
Offsetter Enabled This entry allows setting whether an installed Offsetter
postprocessing device is being used. The host system will
send “Alternate Offset Stacker” commands if the offsetter
is enabled and the print job contains these commands.
YesorNo
Offset on Mark
Forms
This entry allows setting whether “Alternate Offset
Stacker” commands from the host system are passed on
to an enabled stacking-type postprocessing device for any
page containing the Mark Forms.
YesorNo
3130 Bar Code
Compatibility
This entry defines whether bar codes are printed in the
standard format or in the format printed by a 3130
printer.
YesorNo
226 InfoPrint 3000 Operator’s Guide