Filter
Top Products
Thread/Align Forms
Select this task when you load forms in duplex mode. This procedure is also
automatically called when the system is powered-on in duplex mode and during
some error and jam recovery procedures.
All of the controls you need to accomplish this procedure are available on the
Display Touch Screen windows.
This procedure initially displays a Setup Thread/Align Forms window (see
Figure 30).
Notes:
1. Proper completion of this task is important to ensure that Printer 2 prints side 2
pages correctly opposite the side 1 pages that were previously printed by
Printer 1.
2. You can print verification marks on both sides of the pages by using the
Verification marks Printer Configuration Item. You can then visually inspect
these marks to ensure that sides 1 and 2 of the forms are properly
synchronized. See “Verification Marks” on page 224 for more information.
3. The dashed line is used to align the forms in the printers. The solid line is used
to align postprocessing equipment if any is attached.
1. SELECT which of the conditions you want from the Select a Starting
Condition box on the window. Your choice is highlighted.
The conditions you can select on this window are:
v Forms are threaded through both printers:
Select this when:
Figure 30. Setup Window for Thread/Align Forms
152 InfoPrint 3000 Operator’s Guide
|
|