Filter
Top Products
The printer has two configuration modes, Power On Configuration mode and
Program Configuration mode. The values for these parameters are stored in the
printer nonvolatile memory (NVM), an internal printer storage location that is not
erased when the printer is powered off or unplugged. Updating storage can take as
long as 15 seconds to complete.
v Power On Configuration Mode: A printer state that allows you to personalize
hardware and emulation-specific printer parameters. A discussion of this begins
on page 82.
v Program Configuration Mode: A printer state that allows you to complete the
customization of your printer. Program Configuration values can be saved for
each of as many as five forms paths. This mode is always selected while the
printer is in a
wait
condition (Online indicator off) or
ready
condition without
printing. A discussion of this begins on page 106.
See 119 for an additional entry point to the Power On Configuration menu.
Entering Printer Configuration
Use the Menu/Enter key to enter the Printer Configuration menus.
Power On Configuration:
1. Power off (O) the printer.
2. Press and hold Menu/Enter.
3. Power on (|) the printer.
4. Release Menu/Enter after power-on initialization is complete.
For more information about power-on configuration values, see “Power On
Configuration” on page 82, and for more information about entering power on
configuration from another path, see “Additional Entry Point to Power On
Configuration Menu” on page 119.
Program Configuration:
1. Power on (|) the printer if it is not powered on).
Figure 44. Function Keys with Two Functions
Chapter 4. Configuring Your Printer 81