Filter
Top Products
v Select-In Signal
v Data Bit
v Buffer Size
v Emulation
v Character Sets
v Print Language
v Automatic Carriage Return on Line Feed
v Automatic Line Feed on Carriage Return
v 20 CPI
v NLQ
Interface Type
You can set the system interface to match the interface that is attached to your
printer.
v CX Parallel (default)
v 1284 Byte
v 1284 Nibble
To change or check the Interface Types:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message PARALLEL INTF displays.
5. Press → until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL, 1284 BYTE,or1284 NIBBLE. If you want to select a value other
than the one displayed, press ← or →.
6. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Select-In Signal
You can set the select-in signal to:
On The Select-In signal is ignored and treated as always on.
Host (default) The printer checks the Select-In signal from the host.
To change or check the Select-In Signal:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message PARALLEL INTF displays.
5. Press → until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL, 1284 BYTE,or1284 NIBBLE.
6. Press ↓ until the message SELECT-IN=xxxx displays, where xxxx can be ON or
HOST. If you want to select a value other than the one displayed, press ← or →.
Chapter 4. Configuring Your Printer 85