Filter
Top Products
4. Press ↓ until the message VERT ADJUST=xxx displays, where xxx can be -24 to
24. If you want to select a value other than the one displayed, press ← or →.
5. To exit from Program Configuration, press ↓ until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ← or → to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Form Setting
This category contains the following parameters for setting a specific forms path:
v Line Spacing
v Line Spacing Lock
v Page Length
v Top of Form
v Perforation Skipping
v Font
v Pitch
v Pitch Lock
v Left Margin
v Right Margin
v Slashed Zero
v Restore Mfg Defaults
Line Spacing
You can set vertical spacing in lines-per-inch or in lines-per-30 mm on your printer.
Available values are:
v 6 LPI (default)
v 8 LPI
v 12 LPI
v 3L/30MM
v 4L/30MM
v 6L/30MM
v 8L/30MM
v 12L/30MM
To change or check the Line Spacing value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓ until the message FORM SETTING displays.
3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM,or12L/30MM. If you want
to select a value other than the one displayed, press ← or →.
4. To exit from Program Configuration, press ↓ until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ← or → to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Chapter 4. Configuring Your Printer 113