Filter
Top Products
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓ until the message FORM SETTING displays.
3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM,or12L/30MM.
4. Press ↓ until the message TOP OF FORM=xxx displays, where xxx can be 0 to 660.
If you want to select a value other than the one displayed, press ← or →.
5. To exit from Program Configuration, press ↓ until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ← or → to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Perforation Skipping
You can set the number of units you want skipped over the perforation from 0 to
660 units (where each unit is 4.23 mm [1/6 in.]). The default value is 0.
To change or check the Perforation Skipping value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓ until the message FORM SETTING displays.
3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM,or12L/30MM.
4. Press ↓ until the message SKIP PERF=xxx displays, where xxx can be 0 to 660.If
you want to select a value other than the one displayed, press ← or →.
5. To exit from Program Configuration, press ↓ until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ← or → to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Font
You can set the font on your printer to any of the following values:
v DP (default)
v DP Text
v Courier
v Gothic
v OCR-A
v OCR-B
To change or check the Font value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓ until the message FORM SETTING displays.
3. Press → until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI, 8 LPI, 12 LPI, 3L/30MM, 4L/30MM, 6L/30MM, 8L/30MM,or12L/30MM.
4. Press ↓ until the message FONT=xxxxxxx displays, where xxxxxxx can be DP, DP
TEXT, COURIER, GOTHIC, OCR-A,orOCR-B. If you want to select a value other than
the one displayed, press ← or →.
5. To exit from Program Configuration, press ↓ until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
Chapter 4. Configuring Your Printer 115