Filter
Top Products
Parity
You can set parity to any of the following values:
v None (default)
v Odd
v Even
v Mark
v Space
To change or check the Parity:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message SERIAL INTERFACE displays.
5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO, RS-232C,orRS-422A.
6. Press ↓ until the message PARITY=xxxxx displays, where xxxxx can be NONE,
ODD, EVEN, MARK,orSPACE. If you want to select a value other than the one
displayed, press ← or →.
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Pacing Protocol
You can set pacing protocol to either of the following values:
v DTR (default)
v XON/XOFF
To change or check the Pacing Protocol:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message SERIAL INTERFACE displays.
5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO, RS-232C,orRS-422A.
6. Press ↓ until the message PACING=xxxxxxx displays, where xxxxxxx can be DTR
or XON/XOFF. If you want to select a value other than the one displayed, press ←
or →.
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Connection Type
You can set the connection type to either of the following values:
Local (default)
Printer is connected locally to a host computer.
Chapter 4. Configuring Your Printer 93