Filter
Top Products
15. Close the forms guide and the top cover.
16. Press Load/Form Feed to load the forms.
17. Press Online to make the printer
ready
.
Your 4247 Printer is ready to print. See “Printing Power On Configuration Setup” on
page 27 and “Printing Program Configuration Setup” on page 28 to print the
configuration. If you do not want to use the printer defaults for forms settings (such
as Line Spacing, Page Length, or Top of Form), see “Program Configuration” on
page 106.
Setting Up Dual Push Forms Paths
This forms path configuration lets you alternate between the Front Push and Rear
Push forms paths. You can have forms loaded in the Front Push position and
additional forms loaded in the Rear Push position, or you can have the same type
of forms loaded in both positions. If the same type of forms are loaded in both
forms paths and you want the printer to alternate automatically from Front Push to
Rear Push or vice versa, set Sequence=FR+RR in the Power On Configuration
Menu (see “Configuring Printer for Linking Dual Push” on page 59).
If you have different forms types loaded in the Front Push forms path than in the
Rear Push forms path, the operator or the job must ensure that the correct forms
path is used. See “Parking One Continuous Form and Loading Another (Dual
Push)” on page 59.
Figure 36 on page 58 shows the Dual Push forms paths with Manual Sheet Feed.
Figure 35. Aligning Forms for Rear Push Forms Path
Chapter 3. Setting Up Another Forms Path 57