Filter
Top Products
6. Close the forms guide and top cover.
Configuring Forms Path for Rear Pull
To configure the printer for the Rear Pull forms path:
1. Enter Power On Configuration mode:
a. Press and continue to hold Menu/Enter while powering on (|) the printer,
until (1) the message STARTING UP appears, (2) the boxes on the operator
panel display are solidly filled in, and (3) the printhead stops. This takes
about fifteen seconds. Do not release the key or press any other keys until
this completes.
b. Press Online to quiet the audible alarm.
2. Release Menu/Enter and the message PRINT OUT=NO displays.
3. Press ↓ and the message PULL=xxxxxxxxx displays, where xxxxxxxxx can be NO,
YES,orPUSH+PULL. If xxxxxxxxx is not YES, press ← or → until YES is displayed.
Chapter 3. Setting Up Another Forms Path 63