Filter
Top Products
Set the Push-Pull selector as follows:
1. Press Online to take the printer offline.
2. Open the top cover and the forms guide, and locate the Push Pull selector. Use
Table 8 on page 46 to help you set the selector.
Push position—Slide the Push-Pull selector down and to the rear. Ensure that
the upper and the lower gears are correctly positioned, as shown for push.
Pull position—Slide the Push-Pull selector up and to the front. Ensure that the
upper and the lower gears are correctly positioned, as shown for pull.
3. Close the forms guide and the top cover.
Removing or Installing Paper Bail
See Table 9 to determine if the paper bail should be installed or not installed for
your selected forms path.
Table 9. Installing or Not Installing the Paper Bail
Front Push
with Manual
Rear Push
with Manual
Dual Push
with Manual
Rear Pull Push Pull
Paper Bail Installed Installed Installed Not Installed Installed
Figure 23. The Push-Pull Selector. The arrows and words “Push” and “Pull” are provided
here for clarity.
Chapter 3. Setting Up Another Forms Path 47