Filter
Top Products
Baud Rate
You can set baud rate to any of the following values:
v 300
v 600
v 1200
v 2400
v 4800
v 9600 (default)
v 19200
v 38400
To change or check the Baud Rate:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message SERIAL INTERFACE displays.
5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO, RS-232C,orRS-422A.
6. Press ↓ until the message BAUD=xxxxx displays, where xxxxx can be 300, 600,
1200, 2400, 4800, 9600, 19200,or38400. If you want to select a value other than
the one displayed, press ← or →.
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Data Bits
You can set data bit to either of the following values:
v 8 (default)
v 7
To change or check the Data Bits:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓ until the message SERIAL INTERFACE displays.
5. Press → until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO, RS-232C,orRS-422A.
6. Press ↓ until the message DATA BITS=x displays, where x can be 8 or 7.Ifyou
want to select a value other than the one displayed, press ← or →.
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
92 4247 Printer Model A00 User’s Guide