Filter
Top Products
If a forms tractor is not set to the desired position, perform the following:
1. With the forms tractor positioned as shown in Figure 29, move the release
levers in the direction indicated and move the edge of the forms tractor to the
new position.
2. Ensure that the forms tractor fully locks into position. Position 1 is for the Rear
Pull forms tractor in either the Rear Pull or Push Pull mode.
Next, you will perform the following tasks for your selected forms path.
1. Install the necessary tractors.
2. Configure the printer for the selected forms path.
3. Load your forms.
4. Print the configuration for future reference and to verify printer operation.
Figure 29. Setting Forms Tractors
Chapter 3. Setting Up Another Forms Path 51