Filter
Top Products
Table 2. Operator Panel Function Keys (continued)
Function Key Description
Condition 1 Press Park, if continuous forms are loaded in the print
area. The message 94 PARK:SURE? displays.
Press Park again (within 3 seconds), to park the continuous forms
that are in the Front Push, Rear Push, or Push Pull forms path or to
eject the forms in the Rear Pull path.
Before parking a form in the Front Push or Rear Push forms path,
press Tear and then tear the form at the tear bar.
Before parking a form in the Rear Pull or Push Pull forms paths,
tear the form off at the perforation below the front tractor cover.
Condition 2 If the printer is currently in Manual Sheet Feed mode,
press Park to eject a single cut-sheet page. The message 91 EJECT
FORM displays.
Condition 1 and Condition 2
If parking or ejecting does not result in clearing the forms jam
sensor within 24 inches, forms movement is stopped and a 02
FORMS JAM message displays. Press Online to clear the message.
If you wish to leave the Park function, press Online again.
Function 1 Micro ↑ Use this key for adjusting forms.
Press this key. The message MICRO FEED UP displays and the forms
move up in micro steps at an increasing speed (runs at a reduced
speed when the cover is open and the printer is offline).
Press and hold the Micro ↑ to process a continuous movement of
the forms.
For safety reasons, when the cover is open and the printer is
offline, only Micro ↑ and Micro ↓ are operational.
Function 2 ↑ Active only in Power On Configuration or Program
Configuration mode.
Press ↑ to scroll backward to the previous configuration menu
items.
Function 1 Font Use this key to select the available fonts (DP, DP
Text, Courier, Gothic, OCR-A, or OCR-B) for printing.
If you press Font while a job is printing, the current line finishes
printing before the new font takes affect.
If you select an available font which is not compatible with the pitch
currently selected, the default pitch for that font is automatically
selected.
Function 2 ← Active only in Power On Configuration mode or
Program Configuration mode.
Press ← to scroll backward through the previous values of a
selected configuration menu item.
Chapter 1. Printer Setup 11