Filter
Top Products
126
XS712T Smart Switch
2. To configure MLD settings for a physical port, enter the interface and click Go to select that
particular interface.
3. Select
the interfaces for which you want to configure the CoS settings:
• T
o configure MLD settings for a Link Aggregation Group (LAG), click LAGS.
• T
o configure MLD settings for both physical ports and LAGs, click ALL.
4. Select all physical, VLAN and LAG inte
rface you want to configure in the Interface field.
5. Select the interface mode for
the selected interface for MLD Snooping for the switch from
the Admin Mode field.
The default is disable.
6. Use
the Group Membership Interval field to specify the amount of time you want the switch
to wait for a report for a particular group on a particular interface before it deletes that
interface from the group.
The valid range is from (2 to 3600) seconds. The configured value must be greater than
Max Resp
onse Time. The default is 260 seconds.
7. Use the Max
Response Time field to specify the amount of time you want the switch to wait
after sending a query on an interface because it did not receive a report for a particular
group on that interface.