Filter
Top Products
289
XS712T Smart Switch
You can assign an optional sequence number to indicate the order of this access list
relative to other access lists if any are already assigned to this interface and direction.
4. The MAC Binding Table displays the interface and MAC ACL binding information (see MAC
Binding Table on page 219).
The ACL named Sales_ACL looks for Ethernet frames with destination and source MAC
addresses and MAC masks defined in the rule. Also, the frame must be tagged with VLAN ID
2, which is the Sales department VLAN. The CoS value of the frame must be 0, which is the
default value for Ethernet frames. Frames that match this criteria are permitted on interfaces
6, 7, and 8 and are assigned to the hardware egress queue 0, which is the default queue. All
other traffic is explicitly denied on these interfaces. To allow additional traffic to enter these
ports, you must add a new permit rule with the desired match criteria and bind the rule to
interfaces 6, 7, and 8.
Sample Standard IP ACL Configuration
The following example shows how to create an IP-based ACL that prevents any IP traffic
from the Finance department from being allowed on the ports that are associated with other
departments. Traffic from the Finance department is identified by each packet’s network IP
address.
1. From the IP ACL screen, create a new IP ACL with an IP ACL ID of 1 (see IP ACL on
page 220).
2. From the IP Rules screen, create a rule for IP ACL 1 with the following settings:
• Rule ID. 1
• Action. Deny
• Assign Queue ID. 0 (optional: 0 is the default value)
• Match Every. False
• Source IP Address. 192.168.187.0
• Source IP Mask. 255.255.255.0
For additional information about IP ACL rules, see IP Rules on page 221.
3. Click Add.
4. From the IP Rules screen, create a second rule for IP ACL 1 with the following settings:
• Rule ID. 2
• Action. Permit
• Match Every. True
5. Click Add.
6. From the IP Binding Configuration screen, assign ACL ID 1 to the Ethernet ports 2, 3, and 4,
and assign a sequence number of 1 (see
IP Binding Configuration on page 230).
By default, this IP ACL is bound on the inbound direction, so it examines traffic as it
enters the switch.
7. Click Apply.