Filter
Top Products
267
XS712T Smart Switch
Dual Image Configuration
The system running a legacy software version will ignore (not load) a configuration file
created by the newer software version. When a configuration file created by the newer
software version is discovered by the system running an older version of the software, the
system will display an appropriate warning to the user.
Use the Dual Image Configuration screen to set the boot image, configure an image
d
escription, or delete an image.
To configure dual image settings:
1. Select Mainte
nance > File Management > Dual Image > Dual Image Configuration.
2. In the Image Name field, select one of the images.
The Current-active field displays the name of the active image.
3. In the Image Description
field, type a description.
4. T
o set the selected image as the active image, select the Activate Image check box.
Note: After activating an image, you must perform a system reset of the
switch to run the new code.
5. To remove the selected image from permanent storage on the switch, select the Delete
Image check box.
You cannot delete the active image.
6. Click App
ly.