Filter
Top Products
232
XS712T Smart Switch
VLAN Binding Table
Use the VLAN binding table screen to associate an ACL with a VLAN.
To configure an ACL-to-VLAN binding:
1. Select Security
ACL > Advanced Vlan Binding Table.
2. In the VLAN ID field, specify a VLAN ID for ACL mapping.
3. In
the Direction field, specify the direction of packet traffic affected by the ACL, which can be
Inbound or blank.
4. (Opt
ional) In the Sequence Number field, specify the sequence number of the access lists.
This sequence number indicates the order of this access list relative to other access lists
already assigne
d to this VLAN and direction. A lower number indicates higher precedence
order. If a sequence number is already in use for this VLAN and direction, the specified
access list replaces the currently attached access list using that sequence number. If the
sequence number is not specified by the user (i.e., the value is 0), a sequence number that is
one greater than the highest sequence number currently in use for this VLAN and direction
will be used. Valid range is (1 to 4294967295).
5. From
the ACL Type list, select the type of ACL:
• IP ACL
• MAC ACL
• IPv6 ACL
6. From
the ACL ID list, select the ID of the ACL to bind to the specified VLAN.
The ACL ID field displays all the ACLs configured, depending on the ACL Type selected.
7. Click Add.
To delete a VLAN binding:
1. Select the check box
next to the VLAN with the ACL binding to remove.
2. Click Delete.