Filter
Top Products
280
XS712T Smart Switch
2. In the IP Address/Host Name field, specify the IP address or the host name of the station
you want the switch to ping. The initial value is blank. This information is not retained across
a power cycle.
3. Configu
re the following settings:
• In the
Count field, specify the number of pings to send. The valid range is 1–15.
• In the
Interval (secs) field, specify the number of seconds between pings sent. The
valid range is 1–60.
• In
the Size field, specify the size of the ping (ICMP) packet to send. The valid range is
0–65507.
• The Pin
g field displays the result after the switch send a Ping request to the specified
address.
4. Click Apply
to initiate the ping.
The switch sends the number of pings specified in the Count field, and the results are
displa
yed below the configurable data in the Ping area:
• If successfu
l, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x,
Rx = x Min/Max/Avg RTT = x/x/x msec.”
• If a re
ply to the ping is not received, you will see “Reply From IP/Host: Destination
Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.