Filter
Top Products
79
XS712T Smart Switch
port’s maximum capability (full duplex and 10 Gbps) will be advertised. Otherwise,
your selection will determine the port’s duplex mode and transmission rate. The
factory default is Auto.
• Phy
sical Status. Indicates the physical port’s speed and duplex mode
• L
ink Status. Indicates whether the Link is up or down.
• L
ink Trap. This object determines whether or not to send a trap when link status
changes. The factory default is Enable.
- Enable. S
pecifies that the system sends a trap when the link status changes.
- Disable. S
pecifies that the system does not send a trap when the link status
changes.
• Maxim
um Frame Size. Specifies the maximum Ethernet frame size the interface
supports. The size includes the Ethernet header, CRC, and payload. Any change to
the maximum frame size is immediately applied to all interfaces.
• M
AC Address. Displays the physical address of the specified interface.
• PortList Bit Offset. Disp
lays the bit offset value which corresponds to the port when
the MIB object type PortList is used to manage in SNMP.
• i
fIndex. The ifIndex of the interface table entry associated with this port. If the
interface field is set to All, this field is blank.
5. Click App
ly.
Flow Control
IEEE 802.3x flow control works by pausing a port when the port becomes oversubscribed
and dropping all traffic for small bursts of time during the congestion condition. This can lead
to high-priority and/or network control traffic loss. When IEEE 802.3x flow control is enabled,
lower speed switches can communicate with higher speed switches by requesting that the
higher speed switch refrains from sending packets. Transmissions are temporarily halted to
prevent buffer overflows.
To configure global flow control settings:
1. Select Switch
ing Ports > Flow Control.
2. Enable or disable IEEE 802.3x flow control on the system from the Global Flow Control
(IEEE 802.3x) Mode field.
The factory default is Disable.
• Enable. Th
e switch sends pause packets if the port buffers become full.
• Dis
able. The switch does not send pause packets if the port buffers become full.
3. Click App
ly.