Filter
Top Products
174
XS712T Smart Switch
3. In the Timeout Duration field, specify the timeout value, in seconds, for request
retransmissions.
Consideration to maximum delay time should be given when configuring RADIUS maximum
re
transmit and RADIUS timeout. If multiple RADIUS servers are configured, the maximum
retransmit value on each will run out before the next server is attempted. A retransmit will not
occur until the configured timeout value on that server has passed without a response from
the RADIUS server. Therefore, the maximum delay in receiving a response from the RADIUS
application equals the product of (retransmit times timeout) for all configured servers. If the
RADIUS request was generated by a user login attempt, all user interfaces will be blocked
until the RADIUS application returns a response.
4. From the Accounting
Mode menu, select whether the RADIUS accounting mode is enabled
or disabled on the current server.
5. Click Apply.
RADIUS Server Configuration
Use the RADIUS Server Configuration screen to view and configure various settings for the
current RADIUS server configured on the system.
To configure a RADIUS server:
1. Select Security
Management Security > RADIUS Server Configuration.
2. To add a RADIUS server, specify the following settings:
• In the
Server Address field, specify the IP address of the RADIUS server to add.
• In the Auth
entication Port field, specify the UDP port number the server uses to verify
the RADIUS server authentication. The valid range is 1–65535. The default value is
1812.
• From the Secret Configured
menu, select Yes to add a RADIUS secret in the next
field. You must select Yes before you can configure the RADIUS secret. After you add
the RADIUS server, this field indicates whether the shared secret for this server has
been configured.
• In the
Secret field, type the shared secret text string used for authenticating and
encrypting all RADIUS communications between the switch and the RADIUS server.
This secret must match the RADIUS encryption.
• From the Active
menu, specify whether the server is a Primary or Secondary server.
• From the Message Auth
enticator menu, enable or disable the message authenticator
attribute for the selected server.
3. Click Add.