Filter
Top Products
138
XS712T Smart Switch
IP Configuration
Use the IP Configuration screen to configure routing parameters for the switch.
To enable routing on the switch:
1. Select Routing
IP > IP Configuration.
2. Next to Routing Mode, select Enable.
You must enable routing for the switch before you can route through any of the interfaces.
Routin
g is also enabled or disabled per VLAN interface. The default value is Disable.
The following table describes the IP configuratio
n information displayed on the screen.
Field Description
Default Time to Live The default value inserted into the Time-To-Live field of the IP
he
ader of datagrams originated by the switch, if a TTL value is not
supplied by the transport layer protocol. The default value is 64.
Maximum Next Hops The maximum number of hops supported by the switch. This is a
compil
e-time constant. The default value is 1.
3. Click Apply.
IP Statistics
The statistics reported on the IP Statistics screen are as specified in RFC 1213.
To display the IP statistics screen:
Select Routing
IP >Statistics. The IP Statistics screen displays.