Filter
Top Products
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 5-29
Configuring Port Parameters
VTP Snooping Select Enable to allow VTP Snooping on this port. Disable is
the default.
Allow
Learning
Select Disable to keep the port from learning new MAC
addresses and forwarding them to the Supervisor module to
be added to the VLANs AFT. Enable is the default.
Note: If a MAC address is moved to a different VLAN, it will
co-exist in AFTs, one entry for each VLAN (This is a
benefit of having multiple forwarding databases).
Hunt Group Select a hunt group for which this port will be a member.
None is the default.
Spanning Tree
Mode
Select Disable to remove STP on this port. Enable is the
default.
Fast Start Select Enable for fast start on this port. Disable is the default.
Intrusion Trap Specifies whether or not the port will insert an intrusion trap.
Intrusion Trap
Timer
Specifies the time when the intrusion trap will occur.
Known Mode Specifies whether or not the port will broadcast traffic with
an unknown destination in the address forwarding table
(e.g., destination unknown unicast packets). Disable allows
broadcast traffic with an unknown destination to be
transmitted over the port (default). Enable allows the port to
only forward frames with known destinations in the address
forwarding table.
3Com Mapping
Table
Select how incoming tagged frames from 3Com equipment
are mapped to Avaya VLANs. The default value is
3ComDefault.
Mirror Port Displays the status of the mirror port (enabled or disabled).
This is a Fast Ethernet only option.
Auto Flush on
Link down
Select enable Auto Flush for a port to mark all entries learned
on that port invalid if the link to that port fails.
Table 5-5. Switch Port Configuration Parameters
Parameter Definition
2 of 2