Filter
Top Products
5-34 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter 5
CLI Command To configure Fast Start mode for ports on a module associated with a
selected bridge using the CLI, enter the following command from
Configure mode:
<configure># set port fast-start <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for more details about this
command.
Enabling the Auto Flush Feature
Overview The Auto Flush feature has been added to the switch on both a per-
port, and per module basis. When you enable Auto Flush for a port,
and the link to that port fails, all entries in the address forwarding
table learned on that port are marked invalid. You should enable
Auto Flush on all P58x and P88x ports that are participating in a
Port Redundancy configuration with a P330.
Web Agent
Procedure
To enable Auto Flush by using the Web Agent, use the following
procedure:
7. In the Web Agent navigation pane, expand the System >
Modules and Ports folders.
8. Select the Configuration Web Page.
9. In the Module Information pane, click the port link in the
Switch Port column that you want to enable auto-flush for.
10. On the Switch Ports web page, click either the port link in the
Name column that you want to enable auto-flush for, or
11. Click the All Module Switch Ports Configuration link if you
want to enable auto-flush for all ports within the module.
12. Select enable from the Auto Flush on Link Down pull-down
menu on the Switch Port Configuration page.
13. Click Apply to save changes, or Cancel to exit the Web page
without saving your changes.