Filter
Top Products
11-36 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter
CLI Commands
for OSPF
To set up NBMA neighbors on OSPF, you must first create an OSPF
interface.
1. After you create an OSPF interface, enter the following
command:
router ospf
The following prompt is displayed:
Avaya(configure router:ospf)#
2. Enter the following command at the prompt:
nbma-neighbor <ip address>
To remove the OSPF NBMA neighbor, enter the following
command at the Avaya(configure router:ospf)# prompt:
no nbma-neighbor <ip address>
Removing NBMA Neighbors
You can remove NBMA neighbors using either the web agent or the
CLI.
Using the Web
Agent
To remove the NBMA neighbors using the web agent:
TBD
Using the CLI
To remove the NBMA neighbors using the CLI, enter the following
command at the Avaya(configure router:rip)# prompt:
no nbma-neighbor <ip address>
* Note: Do not change the type of interface after you have
created it. If you need to change the interface type,
delete the old one and create a new one.
* Note: Poll-interval of NBMA interface decreases in value to 0,
during the operation. It does not affect the operation of
OSPF on an NBMA interface. A panic message will
display. Ignore this message.
* Note: NBMA RIP2 Poison Reverse in MD5 mode does not
advertise all the routes in the Route Table.