Filter
Top Products
LGB5128A User Manual
136
Queue Scheduler Percent :
Shows the weight in percent for this queue. This parameter is only shown if "Scheduler
Mode" is set to "Weighted."
Port Shaper Enable :
Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate :
Controls the rate for the port shaper. The default value is 500. This value is restricted to 1–
1000 when the "Unit" is "kbps", and it is restricted to 100 when the "Unit" is "Mbps".
. Port Shaper Unit :
Controls the unit of measure for the port shaper rate as "kbps" or "Mbps." The default value
is "kbps."
. Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
3-16.4 Port Shaping
This section provides an overview of QoS Egress Port Shaping for all switch ports. It
describes detailed information for the ports that currently belong to the selected stack unit, as
reflected by the page header.
Web Interface
To display the QoS Port Shapers in the Web interface:
1. Click Configuration, QoS, Port Shapers.
2. Display the QoS Egress Port Shapers.
Figure 3-18.4: The QoS Egress Port Shapers
Click&the&Port&index&to&set&the&QoS&
Egress&Port&Shapers&