Filter
Top Products
LGB5128A User Manual
140
3-16.6 Port DSCP
The section will teach the user how to set the QoS Port DSCP configuration that allowed you
to configure the basic QoS Port DSCP Configuration settings for all switch ports. The settings
relate to the currently selected stack unit, as reflected by the page header.
Web Interface
To configure the QoS Port DSCP parameters in the Web interface:
1. Click Configuration, QoS, Port DSCP.
2. Evoke to enable or disable the Ingress Translate and Scroll the Classify
Parameter configuration.
3. Scroll to select Egress Rewrite parameters.
4. Click the save button to save the setting.
5. If you want to cancel the setting, then you need to click the Reset button.
It will revert to previously saved values
Figure 3-16.6: The QoS Port DSCP Configuration
Parameter description:
Port :
The Port column shows the list of ports for which you can configure dscp ingress and
egress settings.
Ingress :
In Ingress settings, you can change ingress translation and classification settings for
individual ports.
There are two configuration parameters available in Ingress:
1. Translate : To Enable the Ingress Translation, click the checkbox.
2. Classify: Classification for a port have 4 different values.
• Disable: No Ingress DSCP Classification.
• DSCP=0: Classify if incoming (or translated if enabled) DSCP is 0.
• Selected: Classify only selected DSCP for which classification is enabled as specified
in DSCP Translation window for the specific DSCP.