Filter
Top Products
209
Secret :
The secret—up to 29 characters long—shared between the TACACS+ Authentication
Server and the switch stack.
Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
4-6.2 Radius Overview
This section shows you an overview of the RADIUS Authentication and Accounting servers
status to ensure the function is workable.
Web Interface
To configure a RADIUS Overview Configuration in the Web interface:
1. Check “Auto-refresh.”
Figure 4-6.2: The RADIUS Authentication Server Status Overview
Parameter description:
# :
The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address :
The IP address and UDP port number (in <IP Address>:<UDP Port> notation) of this
server.
State :
The current state of the server. This field has one of the following values:
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS
module is ready to accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it did not reply within
the configured timeout. The server has temporarily been disabled, but will get re-enabled
when the dead-time expires. The number of seconds left before this occurs is displayed in
parentheses. This state is only reachable when more than one server is enabled.
RADIUS Accounting Servers
# :
The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address :