Filter
Top Products
11
Privilege Level :
The privilege level of the user. The allowed range is 1 to 15. If the privilege
level value is 15, the user can access all groups, i.e. he is granted the full
control of the device. Other values need to refer to each group privilege level.
A user’s privilege should be same or greater than the group privilege level to
access that group. By default, most groups privilege level 5 has read-only
access and privilege level 10 has read-write access. For system maintenance
(software upload, factory defaults and etc.), a user will need user privilege
level 15. Generally, the privilege level 15 can be used for an administrator
account, privilege level 10 for a standard user account, and privilege level 5 for
a guest account.
2-3.2 Privilege Level
This page provides an overview of the privilege levels. The switch provides user-set Account,
Aggregation, Diagnostics, EEE, GARP, GVRP, IP, IPMC Snooping, LACP, LLDP, LLDP,
MED, MAC, Table, MRP, MVR, MVRP, Maintenance, Mirroring, POE, Ports, Private VLANs,
QoS, SMTP, SNMP, Securit,y Spanning Tree, System Trap Event, VCL, VLANs Voice VLAN
Privilege Levels from 1 to 15 .
Web Interface
To configure Privilege Level in the Web interface:
1. Click SYSTEM, Account, Privilege Level.
2. Specify the Privilege parameter.
3. Click Save.