Filter
Top Products
LGB5128A User Manual
56
Web Interface
To configure the Spanning Tree MSTI Priorities parameters in the Web interface:
1. Click Configuration, Spanning Tree, MSTI Priorities.
2. Scroll the Priority. The maximum is 240. Default is 128.
3. Click the save button to save the setting
4. If you want to cancel the setting, then you need to click the Reset button. It will revert to
previously saved values
Figure 3-4.3: The MSTI Configuration
Parameter description:
MSTI :
The CIST is the default bridge instance, which is always active.
Priority :
Controls the bridge priority. Lower numeric values have better priority. The
bridge priority plus the MSTI instance number, concatenated with the 6-byte
MAC address of the switch, forms a Bridge Identifier.
Buttons
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
3-4.4 CIST Ports
When you implement a Spanning Tree protocol on the switch, you need to configure the CIST
Ports. This section describes how to inspect the to inspect the current STP CIST port
configurations, and possibly change them as well.
Web Interface
To configure the Spanning Tree CIST Ports parameters in the Web interface:
1. Click Configuration, Spanning Tree, CIST Ports.
2. Scroll and evoke to set all parameters of CIST Aggregated Port Configuration.
3. Enable or disable the STP, then scoll to set all parameters of the CIST normal Port
configuration.
4. Click the save button to save the setting.
5. If you want to cancel the setting, then you need to click the Reset button. It will revert to
previously saved values