Filter
Top Products
LGB5128A User Manual
138
Parameter description:
Port :
The logical port for the settings contained in the same row. Click on the port number in
order to configure the shapers.
Shapers (Qn) :
Shows "disabled" or actual queue shaper rate - e.g. "800 Mbps".
Shapers (Port) :
Shows "disabled" or actual port shaper rate - e.g. "800 Mbps".
Scheduler Mode :
Controls whether the scheduler mode is "Strict Priority" or "Weighted" on this switch port.
Queue Shaper Enable :
Controls whether the queue shaper is enabled for this queue on this switch port.
Queue Shaper Rate :
Controls the rate for the queue shaper. The default value is 500. This value is restricted to
1–1000 when the "Unit" is "kbps,” and it is restricted to 1–100 when the "Unit" is "Mbps.”
Queue Shaper Unit :
Controls the unit of measure for the queue shaper rate as "kbps" or "Mbps". The default
value is "kbps".
Queue Shaper Excess :
Controls whether the queue is allowed to use excess bandwidth.
Queue Scheduler Weight :
Controls the weight for this queue. The default value is "17". This value is restricted to 1-
100. This parameter is only shown if "Scheduler Mode" is set to "Weighted".
Queue Scheduler Percent :
Shows the weight in percent for this queue. This parameter is only shown if "Scheduler
Mode" is set to "Weighted"
Port Shaper Enable :
Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate :
Controls the rate for the port shaper. The default value is 500. This value is restricted to 1–
1000 when the "Unit" is "kbps", and it is restricted to 1–100 when the "Unit" is "Mbps".
. Port Shaper Unit :
Controls the unit of measure for the port shaper rate as "kbps" or "Mbps". The default value
is "kbps".
. Buttons:
Save – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.