Filter
Top Products
LGB5128A User Manual
232
5-5.2 Ping6
This section allows you to issue ICMPv6 PING packets to troubleshoot IPv6 connectivity
issues.
Web Interface
To configure an ICMPv6 PING Configuration in the Web interface:
1.Specify ICMPv6 PING IP Address.
2.Specify ICMPv6 PING Size.
3.Click Start.
Figure 5-5.2: The ICMPv6 Ping
Parameter description:
IP Address :
The destination IP Address with IPv6
Ping Size :
The payload size of the ICMP packet. Values range from 8 bytes to 1400 bytes.
Start:
Click the “Start” button and the switch will start to ping the device using ICMPv6 packet
size that is set on the switch.
Five ICMPv6 packets are transmitted, and the sequence number and roundtrip time are
displayed upon reception of a reply. The page refreshes automatically until responses to all
packets are received, or until a timeout occurs.
PING server 10.10.132.20
64 bytes from 10.10.132.20: icmp_seq=0, time=0ms
64 bytes from 10.10.132.20: icmp_seq=1, time=0ms
64 bytes from 10.10.132.20: icmp_seq=2, time=0ms
64 bytes from 10.10.132.20: icmp_seq=3, time=0ms
64 bytes from 10.10.132.20: icmp_seq=4, time=0ms
Sent 5 packets, received 5 OK, 0 bad
You can configure the following properties of the issued ICMP packets: