Filter
Top Products
LGB5128A User Manual
186
4-2.3 Dynamic Table
The section describes how to configure the Dynamic ARP Inspection Table parameters of the
switch. The Dynamic ARP Inspection Table contains up to 1024 entries, and is sorted first by
port, then by VLAN ID, then by MAC address, and then by IP address.
Web Interface
To configure a Dynamic ARP Inspection Table Configuration in the web interface:
1. Specify the Start from port, VLAN ID, MAC Address, IP Address, and entries per page.
2. Check “Auto-refresh.”
.
Figure 4-2.3: The Dynamic ARP Inspection Table
Parameter description:
Port :
Switch Port Number for which the entries are displayed.
VLAN ID :
VLAN-ID in which the ARP traffic is permitted.
MAC Address :
User MAC address of the entry.
IP Address :
User IP address of the entry.
Auto-refresh :
Click the box next to auto-refresh and the device will refresh the information automatically.
Upper right icon (Refresh, <<, >> ):
Click on these icons to refresh the Dynamic ARP Inspection Table manually or to go to the
next/up page or entry