Filter
Top Products
83
3-6.6 IPv6 SSM Information
The section describes how to configure the Entries in the MLDv2 Information Table are shown
on this page. The MLDv2 Information Table is sorted first by VLAN ID, then by group, and
then by Port No. Different source addresses that belong to the same group are treated as a
single entry.
Each page shows up to 64 entries from the MLDv2 SSM (Source Specific Multicast)
Information table, selected through the "entries per page" input field. When first visited, the
web page will show the first 20 entries from the beginning of the MLDv2 Information Table.
The default is 20 entries. The "Start from VLAN", and "group" input fields allow the user to
select the starting point in the MLDv2 Information Table.
Web Interface
To display the MLDv2 IPv6 SSM Information in the Web interface:
1. Click Configuration, MLD Snooping, IPv6 SSM Information.
2. If you want to auto-refresh the information, check the “Auto-refresh” box.
3. Click “ Refresh“ to refresh a entry of the MLDv2 IPv6 SSM Information.
4. Click “<< or >> “ to move to the previous or next entry.
Figure 3-6.6: The IPv6 SSM Information
Parameter description:
MLDv2 Information Table Columns
VLAN ID :
VLAN ID of the group.
Group :
Group address of the group displayed.
Port :
Switch port number.
Mode :
Indicates the filtering mode maintained per (VLAN ID, port number, Group Address) basis.
It can be either Include or Exclude.
Source Address :
IP Address of the source. Currently, the system limits the total number of IP source
addresses for filtering to 128.
Type :
Indicates the Type. It can be either Allow or Deny.