Filter
Top Products
LGB5128A User Manual
194
4-5 NAS
The section describes how to configure the NAS parameters of the switch. You can use the
NAS server to connect users to a variety of resources including Internet access, conference
calls, printing documents on shared printers, or by simply logging on to the Internet.
4-5.1 Configuration
This section describes how to configure NAS setting of IEEE 802.1X, MAC-based
authentication system and port settings. The NAS configuration consists of two sections, a
system- and a port-wide.
Web Interface
To configure a System Configuration of Network Access Server in the Web interface:
1. Select “Enabled” in the Mode of Network Access Server Configuration.
2. Checked Reauthentication Enabled.
3. Set Reauthentication Period (Default is 3600 seconds).
4. Set EAPOL Timeout (Default is 30 seconds).
5. Set Aging Peroid (Default is 300 seconds).
6. Set Hold Time (Default is 10 seconds).
7. Check RADIUS-Assigned QoS Enabled.
8. Check RADIUS-Assigned VLAN Enabled.
9. Check Guest VLAN Enabled.
10. Specify Guest VLAN ID.
11. Specify Max. Reauth. Count.
12. Check Allow Guest VLAN if EAPOL Seen.
13. Click Save.
Figure 4-5.1: The Network Access Server Configuration
Parameter description: