Filter
Top Products
29
Chapter 3. Configuration
This chapter describes all of the basic network configuration tasks, including the Ports,
Layer 2 network protocol (e.g., VLANs, QoS, IGMP, ACLs, and PoE, etc.), and any
setting of the switch.
3-1 Port
The section describes how to configure the Port detail parameters of the switch, to enable or
disable switch Ports, and monitor the ports’ content or status.
3-1.1 Configuration
This chapter describes how to view the current port configuration and how to configure ports to
non-default settings, including:
Linkup/Linkdown
Speed (Current and configured)
Flow Control (Current Rx, Current Tx, and Configured)
Maximum Frame Size
Excessive Collision Mode
Power Control
Web Interface
To configure a Current Port Configuration in the Web interface:
1. Click Configuration, Port, then Configuration.
2. Specify the Speed Configured, Flow Control , Maximum Frame size ,
Excessive Collision mode and Power Control.
3. Click Save.
Figure 3-1.1: The Port Configuration